David, Is there a color break between the underlay and the start of the fill? It should not trim as you have described, unless there is a manual trim or a color break is installed in the design tree. The only other reason I can bring to mind immediately,would be found in the lock/trim tab in properties where you can set the trim distance which is usually set at .252"...... Rod Springer Embroidery Cottage Rod & Sharon Springer Melco Amaya Tech & Trainer Design Shop Pro+ Digitizing Boise, ID 83713 208-938-3038 ----- Original Message ----- From: <dsklar@xxxxxxxxxxx> To: <amayausers@xxxxxxxxxxxxx> Sent: Wednesday, April 05, 2006 10:19 AM Subject: [amayausers] Start for Fill and Underlay Different >I have a small design where there is a fill then a run stitch to the next >fill and the fill start point is right on top of the end of the run stitch. >However, DesignShop Pro+ (v. 608.522) does not want to start the underlay >for the fill at the start point and insert a trim instead. Is there anyway >to control for this in DesignShop? I realise that I can turn off the >underlay and do it maually myself, but I was hoping that there is a way to >get the software to do it automatically. Thanks. > > David Sklar > Ballyhoo! > Arlington, VA >