This message was posted by levelbest on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/11/61.html#000010 I hear you Barbara - but unfortuantely, I'm not in the market to spend another $2k on a second cutter. We like the GX-24 and it's served us very well to this point. I am quite sure a cutter with an overcut function would work well. We did look at the ioline back when but it was too expensive for us personally as a point of entry into heat pressed vinyl - not to mention the gx24 cuts aplique without any problem. You're telling me they said you wouldn't be able to cut anything smaller than a centimeter in diameter (10mm)? That would make the system pretty much useless to sell to any gx-24 owner if that's the case. Do you mean .10? =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================