I am in need of some direction BEFORE I take Big Red out and push her off
the porch making the total transformation into the pile of junk she was
destined to be. I have been working with her part time for the past 5/6
years and I am just plain tired. I had talked with my Melco rep and
didn't
get much help there other than the implication she thought I was nuts. If
you work in the nut house long enough I think you will become an inmate.
I will send 2 sew files that are not that large to anyone willing to try
to
figure me and my machine out. I have 2 pic of the problem as I am
experiencing and this problem is consistent through all designs I sew. (I
have on occasion tested and tested until I got it looking good enough and
then when I see the design later it almost makes me sick)I usually work
with
it till I get it close enough but right now close enough is not good
enough.
The rep told me I didn't
have my mat'l thickness set high enough. On a twill
shirt with cutaway backing I had running at 4 at her direction I changed
it
up to 6, 7, 8 and all I get is bobbin breaks and the design still pulls so
tight it will pull the hole the needle made in the
