[amayausers] Re: Hoops
- From: "Lee or Terri Hoover" <lhoover2@xxxxxxxxxxxxxxxx>
- To: <amayausers@xxxxxxxxxxxxx>
- Date: Wed, 8 Feb 2006 15:12:47 -0600
Hi Sharon,
I was wondering how you replaced the thumb wheel screws with the "end
screws" on this hoop as there is not a hole all the way through the area
that hold the screw. Someone had mention earlier on the list to replace the
thumb wheel screw but I could never figure it out.
Thanks,
Terri
Embroidery Creations
-----Original Message-----
From: amayausers-bounce@xxxxxxxxxxxxx
[mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of Rod or Sharon
Sent: Wednesday, February 08, 2006 1:25 PM
To: amayausers@xxxxxxxxxxxxx
Subject: [amayausers] Re: Hoops
Ah, I have done some of those Russell. Also some vests with the same type
of flap. One other suggestion is to wrap your hoops (sometimes I just use
strips of rubber shelf lining and lay at the loose areas) to make your hoops
fit snuggly. We also replaced the little center screws with the ones that
you tighten from the end--sorry, I don't know the names of those screws--and
it is much easier to tighten them. Maybe that will help keep frames from
popping off. Just a couple thoughts if you haven't already tried them.
Sharon
----- Original Message -----
From: "Russell Silva" <russell@xxxxxxxxxxxxxxxx>
To: <amayausers@xxxxxxxxxxxxx>
Sent: Wednesday, February 08, 2006 11:58 AM
Subject: [amayausers] Re: Hoops
>I have some of those hoops, they are the 17.2 X 11.7, they are a little bit
>to wide for some of the shirt backs I have to do, they need to fit up
>inside of a vent back fishing shirt.
>
> Russell
>
> ----- Original Message -----
> From: "Rod or Sharon" <springer37@xxxxxxxxxxxx>
> To: <amayausers@xxxxxxxxxxxxx>
> Sent: Wednesday, February 08, 2006 12:27 PM
> Subject: [amayausers] Re: Hoops
>
>
>> Hi Russell,
>> I just measured the inside open area of our smallest double hoop and it
>> measures 16.5" X 11.25". Hope this helps.
>> Sharon
>>
>> Embroidery Cottage
>> Rod & Sharon Springer
>> Melco Amaya Tech & Trainer
>> Design Shop Pro+ Digitizing
>> Boise, ID 83713
>> 208-938-3038
>>
>> ----- Original Message -----
>> From: "Russell Silva" <russell@xxxxxxxxxxxxxxxx>
>> To: <amayausers@xxxxxxxxxxxxx>
>> Sent: Wednesday, February 08, 2006 10:12 AM
>> Subject: [amayausers] Hoops
>>
>>
>>> Does anyone know if the 14 X 11.7 hoops are available in wooden double
>>> hight? I have a plastic one but it just doesn't hold good enough for a
>>> large design.
>>>
>>> Thanks in advance
>>> Russell Silva
>>> R. S. Embroidery
>>> 508-222-4433
>>>
>>
>
>
Other related posts:
