This message was posted by EEAmayaTech on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1035.html#000007 It sounds like your thread feed drive gear is cracked. Easy Fix, you can do it yourself. Take apart the upper clam shell covers behind the needle case. You will see a single white plastic drive gear. Laser Up Arrow will advance the threadfeed. You will be able to see the gear wobble in and out of engagement from the threadfeed assembly. You will need a precision small pliers for retaining clips in order to get it off. When you order the gear make sure you also order a couple spare clips, you will loose and/or bend them. Don't forget to grease the inside of the gear with Polymer. To get the gear out you can either order a Fixture (Recommmended) or you can remove the circuit board directly above the gear. If you choose to remove the circuit board make sure you mark exactly where the board is before you remove it. The board can be adjusted front to back to center the drive gear to the thread feed assembly. Good Luck !!! TJ. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================