Dave, c3407 is 220ufd @ 25v it was leaky and i changed it. I've already resoldered most of the main board including the fly. Still dead. On Mon, 8 Oct 2001 10:02:08 -0500, techassist@xxxxxxxxxxxxx wrote: > > Mike, if you haven't replaced C3407 100ufd cap yet do so and then try it. > Also solder TX3401 pins, may look ok > but brads will float on board and cause > no start also. > Dave Routson > > ----- Original Message ----- > From: "Mike Barnett" <passthecash@xxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Monday, October 08, 2001 8:18 AM > Subject: [TechAssist] Zenith SG2589W No power up > > > > > > Zenith Model SG2589W Module# 9-958 > > This unit wont power up, standby 5v is present and have 136 at collector > of > > HOT, vcc at vertical is ok. Checked all caps in power primary and high > > voltage curcuit all are ok. checked resistors near and around fly. > > Any idea's? > > Thanks > > > > > > > > . Get It Fixed At Rochester Electronics 630 West Ridge Rd. Rochester, NY 14615 716.663.6870 www.RochesterElectronicsRepair.com _______________________________________________________ Send a cool gift with your E-Card http://www.bluemountain.com/giftcenter/ Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.