Mike, if you haven't replaced C3407 100ufd cap yet do so and then try it. Also solder TX3401 pins, may look ok but brads will float on board and cause no start also. Dave Routson ----- Original Message ----- From: "Mike Barnett" <passthecash@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, October 08, 2001 8:18 AM Subject: [TechAssist] Zenith SG2589W No power up > > Zenith Model SG2589W Module# 9-958 > This unit wont power up, standby 5v is present and have 136 at collector of > HOT, vcc at vertical is ok. Checked all caps in power primary and high > voltage curcuit all are ok. checked resistors near and around fly. > Any idea's? > Thanks > > > > Get It Fixed At > Rochester Electronics > 630 West Ridge Rd. > Rochester, NY 14615 > 716.663.6870 > www.RochesterElectronicsRepair.com > > > > > > _______________________________________________________ > Send a cool gift with your E-Card > http://www.bluemountain.com/giftcenter/ > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.