My manual suggests this procedure thank you.. I have enough information sounds straight forward ....if there is such a thing. Bruce. B&T Electronics. ----- Original Message ----- From: "Shoreline Electronics" <jstielau@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, September 26, 2001 9:11 PM Subject: [TechAssist] Re: Convergence Problem...... > > You have the static centering rings on each of the CRTS. Make sure the > green is centered to begin with before you mess with the red & blue. > > Cover the red & blue lenses so you can see only the green. > > Then do Green & Red together...then add the blue. > > Jeff Stielau > Shoreline Electronics Repair > 125 Beechtree Lane > Westbrook,CT 06498 > 860-399-1861 Voice > 860-664-3535 Fax > jstielau@xxxxxxxx > > ----- Original Message ----- > From: "Bruce Tiedeman" <btied@xxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, September 26, 2001 8:39 PM > Subject: [TechAssist] Convergence Problem...... > > > > > > Rear Projection RCA . > > PTK 169 PEC (P60752EB) 1995. > > Replaced the HV. Splitter , now have a convergence problem. I was very > > careful not to jar the C.R.T 's. I also made sure the leads where seated > in > > the splitter. > > > > I am at a disadvantage seeing the customer brought the unit to me for > > repair. Regardless I have to fix the problem. Seems the R and blue > > convergence will not adjust up to the green. It is about 1 inch out > > horizontally. > > > > Is there a static adjustment for this condition or is it a yoke tilt > > adjustment ? I have and old service manual from an older projection to > refer > > too. > > > > I need some advice on this , just don't want to get into making > unnecessary > > adjustments and possibly make it worse. > > > > I don't work on that many projection sets am not familiar with their > > adjustments. > > > > Will have to go to the customers house to finish the job. > > > > thanks for any help on this, > > > > Bruce > > B&T Electronics. > > > > > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.