You have the static centering rings on each of the CRTS. Make sure the green is centered to begin with before you mess with the red & blue. Cover the red & blue lenses so you can see only the green. Then do Green & Red together...then add the blue. Jeff Stielau Shoreline Electronics Repair 125 Beechtree Lane Westbrook,CT 06498 860-399-1861 Voice 860-664-3535 Fax jstielau@xxxxxxxx ----- Original Message ----- From: "Bruce Tiedeman" <btied@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, September 26, 2001 8:39 PM Subject: [TechAssist] Convergence Problem...... > > Rear Projection RCA . > PTK 169 PEC (P60752EB) 1995. > Replaced the HV. Splitter , now have a convergence problem. I was very > careful not to jar the C.R.T 's. I also made sure the leads where seated in > the splitter. > > I am at a disadvantage seeing the customer brought the unit to me for > repair. Regardless I have to fix the problem. Seems the R and blue > convergence will not adjust up to the green. It is about 1 inch out > horizontally. > > Is there a static adjustment for this condition or is it a yoke tilt > adjustment ? I have and old service manual from an older projection to refer > too. > > I need some advice on this , just don't want to get into making unnecessary > adjustments and possibly make it worse. > > I don't work on that many projection sets am not familiar with their > adjustments. > > Will have to go to the customers house to finish the job. > > thanks for any help on this, > > Bruce > B&T Electronics. > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.