Water with Tooth brush. Dry with hair dryer,Heat Gun,or 150 degree preheated oven Peggs At 11:11 PM 12/14/02 -0500, Dave Huston wrote: > >This question is not model specific. >What's the best cleaning solution to remove and clean Coke from a chassis >board? >I have a TV in shop that had pop accidentally spilled down the front of the >picture tube and collected inside on the chassis around the IR receiver >circuitry. I'd like to try to clean it before condemning it as unrepairable >if that's possible. This set is just over a year old so I thought I'd try my >best. >Any advice is appreciated. >Dave Huston >Huston TV & Electronics >Marion, Ohio 43302 >DaveHuston@xxxxxxxxxxxx >(740) 389-5726 voice & fax. > >------------------------------------------ >Submit A Repair Tip For Everyone Here: >http://www.tech-assist.org/secure/tip/main.html >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > Peggs' Electronics 1519 West 2nd Street Owensboro,KY 42301 270-926-4968 fax 270-686-7399 ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html