I've been working on CTC169's for ten years but I never found a leaky cap that I can think of...... Bill Grabowski Triangle Appliance "Leonard G. Caillouet" wrote: > > I am wondering if you all have seen many leaky caps in these sets. I just > did two this week that had leaky Nichicon 105 degree caps. The electrolyte > caused enough corrosion to damage a couple of traces. These are the first I > have seen like this and am wondering if we can expect this to be as common > as in the Hitachi and Misubishi projection sets. How far do you guys go in > looking for other caps going bad on these sets. I have found that sometimes > the only way that you can find them is to heat the pins and see if they > smell or remove them and visually inspect them. Many of the ones that are > starting to leak check OK on all four tests, capacitance, ESR, DA, & leakage > current. Should we be checking all of them on these sets? > > Leon. > > Leonard G. Caillouet > Service Manager > Electronics World > Gainesville, FL > 352-332-5608 > 352-332-5668 (fax) > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe