It's all there. I will have it with me and you can look at it and decide. The missing piece does not affect the pin holding the knob on. Someone else might have a knob in better condition. _____ From: tcb-bounce@xxxxxxxxxxxxx [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf Of Fred McDonald Sent: Wednesday, April 14, 2010 12:08 PM To: tcb@xxxxxxxxxxxxx Subject: [tcb] Re: Heater Valve Lyle says I need a complete unit with an intact knob with the pin that holds the knob. ----- Original Message ----- From: Bergman <mailto:bergmanfamily@xxxxxxxxxxxxx> To: tcb@xxxxxxxxxxxxx Sent: Wednesday, April 14, 2010 11:23 AM Subject: [tcb] Re: Heater Valve What I got is all here but the knob has a chip out of it on the underside _____ From: tcb-bounce@xxxxxxxxxxxxx [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf Of Denis Dodson Sent: Wednesday, April 14, 2010 10:58 AM To: tcb@xxxxxxxxxxxxx Subject: [tcb] Re: Heater Valve Do you have that for him? Because I can dig one up, but if you will bring it to him I won't have to. From: tcb-bounce@xxxxxxxxxxxxx [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf Of Bergman Sent: Wednesday, April 14, 2010 10:44 AM To: tcb@xxxxxxxxxxxxx Subject: [tcb] Re: Heater Valve I am guessing you mean the knob and "guts" that pull the cable? I got that. _____ From: tcb-bounce@xxxxxxxxxxxxx [mailto:tcb-bounce@xxxxxxxxxxxxx] On Behalf Of Fred McDonald Sent: Wednesday, April 14, 2010 10:38 AM To: tcb@xxxxxxxxxxxxx Subject: [tcb] Heater Valve I have been trying to complete the stock heating system on my bus. I have everything connected but the heater valve in the cab you use to open & close the system needs to be replaced. I need a complete working valve including the handle. Lyle Cherry has been working on this for me but is not been able to find one. He thinks the beetle & bus are the same.