[modeleng] Flywheels pumps, etc

From: Harry Wade <hww@xxxxxxxx>
To: modeleng@xxxxxxxxxxxxx
Date: Wed, 22 Feb 2006 16:14:21 -0600

At 02:59 PM 2/22/06 -0500, you wrote:
>Sounds like you already "know the drill" for  doing a jacketed rim. - Jeff

Jeff,
       Yes, but sometimes one needs a gentle reminder that there was/is a
"drill."  In this case, since the flywheel is 9"+ in diameter, the slices
would have to be of quite large pipe.  If anyone would like to have a look
at a built example of the engine (with red brass castings) go to
<http://community.webshots.com/photo/547881417/2035951370034675872TqdXbS#

Regards,
Harry

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Follow-Ups:

[modeleng] Re: Flywheels pumps, etc
From: Jeff Dayman

References:
- [modeleng] Re: Lapping, pumps, etc was
  - From: Andrew Houston
- [modeleng] Re: Lapping, pumps, etc was
  - From: Harry Wade
- [modeleng] Re: Lapping, pumps, etc was
  - From: Harry Wade
- [modeleng] pumps, etc was
  - From: Harry Wade
- [modeleng] Re: pumps, etc was
  - From: Harry Wade
- [modeleng] Re: pumps, etc was
  - From: Jeff Dayman

[modeleng] Flywheels pumps, etc

Other related posts: