thomas@xxxxxxxxxx ha scritto: > >> >> prova a postare anche l'output di ifconfig, forse non ho capito bene >> come è configuarto il tutto > > ifconfig > eth0 Link encap:Ethernet HWaddr 00:30:05:49:D0:55 > inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0 > inet6 addr: fe80::230:5ff:fe49:d055/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:320 errors:0 dropped:0 overruns:0 frame:0 > TX packets:189 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:31830 (31.0 KiB) TX bytes:20446 (19.9 KiB) > > eth1 Link encap:Ethernet HWaddr 00:60:4C:30:CD:34 > inet6 addr: fe80::260:4cff:fe30:cd34/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:65535 Metric:1 > RX packets:78117 errors:0 dropped:0 overruns:0 frame:0 > TX packets:40211 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:114432806 (109.1 MiB) TX bytes:2564539 (2.4 MiB) > > ppp0 Link encap:Point-to-Point Protocol > inet addr:80.180.196.168 P-t-P:192.168.100.1 > Mask:255.255.255.255 > UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1 > RX packets:69997 errors:0 dropped:0 overruns:0 frame:0 > TX packets:35900 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:3 > RX bytes:102751859 (97.9 MiB) TX bytes:1591388 (1.5 MiB) > ma togli la route di default route del default e fai cosi route add default dev ppp0 poi vediamo Diaolin > > -- > Per iscriversi (o disiscriversi), basta spedire un messaggio con OGGETTO > "subscribe" (o "unsubscribe") a mailto:linuxtrent-request@xxxxxxxxxxxxx > > > -- Esistono due tipi di problemi: per quelli risolvibili inutile preoccuparsene per quelli irrisolvibili preoccuparsene non cambierebbe nulla. Diaolin -- Per iscriversi (o disiscriversi), basta spedire un messaggio con OGGETTO "subscribe" (o "unsubscribe") a mailto:linuxtrent-request@xxxxxxxxxxxxx