Is it possible that the boundary shape has a fixed property? or Try merging the shape with another dynamic shape that has the same net name. Best regards, -oscar On Fri, Oct 1, 2010 at 10:41 AM, HELEN EFANOV <w18982@xxxxxxxxxxxx> wrote: > Gennadiy, > > On "Global Shape Parameters " form change "Suppress shapes less then" to > really small size (smaller then your shape) > Have been there. > > Thanks, > > Helen > > > > On Fri, Oct 1, 2010 at 12:20 PM, Gennadiy Kiryukhin < > gkiryukhin@xxxxxxxxxxxxxxx> wrote: > >> I have a small shape that I cannot delete it. It does not have the fill >> because of the size and cannot be picked to delete or edit. >> >> Because of that shape I cannot create the artwork file as the software is >> complaining that my shapes are out of date. Updating the shape does not >> help. >> >> How can I delete such shape? I am stuck. >> >> To reproduce the problem I tried creating a small dynamic fill shape (10 x >> 15 mil in size) and I could not delete that one either. >> >> -- >> >> Gennadiy Kiryukhin >> Development Engineer >> ATSI >> 8157 US Route 50 >> Athens, OH 45701 >> Phone: (740) 592-2874 >> Fax (740) 594-2875 >> ----------------------------------------------------------- >> To subscribe/unsubscribe: Send a message to >> icu-pcb-forum-request@xxxxxxxxxxxxx >> with a subject of subscribe or unsubscribe >> >> To view the archives of this list go to >> //www.freelists.org/archives/icu-pcb-forum/ >> >> Problems or Questions: >> Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx >> ----------------------------------------------------------- >> > >