Delete the boundry -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gennadiy Kiryukhin Sent: Friday, October 01, 2010 12:21 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Small shape problem I have a small shape that I cannot delete it. It does not have the fill because of the size and cannot be picked to delete or edit. Because of that shape I cannot create the artwork file as the software is complaining that my shapes are out of date. Updating the shape does not help. How can I delete such shape? I am stuck. To reproduce the problem I tried creating a small dynamic fill shape (10 x 15 mil in size) and I could not delete that one either. -- Gennadiy Kiryukhin Development Engineer ATSI 8157 US Route 50 Athens, OH 45701 Phone: (740) 592-2874 Fax (740) 594-2875 ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------