If it's something you need to do ASAP, and a temp hack job will do for now... take a screenshot of the table and add it to the doc as an image? - Naomi > In FrameMaker 6 on Windows, I have a table that (easily) fits > vertically on the page, but which is too wide for the text column. So > I decrease the width of (any) one of the columns so that the table > fits horizontally. Doing so causes the table to immediately jump to > the next page, leaving a huge gap on the original page. However, > reducing the column width had no effect on text-wrapping within the > table, so its height remains unchanged. > > I then tried inserting a page break into the table to try to get it to > fit vertically. But even if I do so only a few rows (about 3cm) from > the top of the table, the preceding rows remains stubbornly on a page > all of their own. > > Please, what can I do to make the table fit on the original page? > > Thanks, > Craig ************************************************** To post a message to austechwriter, send the message to austechwriter@xxxxxxxxxxxxxx To subscribe to austechwriter, send a message to austechwriter-request@xxxxxxxxxxxxx with "subscribe" in the Subject field. To unsubscribe, send a message to austechwriter-request@xxxxxxxxxxxxx with "unsubscribe" in the Subject field. To search the austechwriter archives, go to www.freelists.org/archives/austechwriter To contact the list administrator, send a message to austechwriter-admins@xxxxxxxxxxxxx **************************************************