> In FrameMaker 6 on Windows, I have a table that (easily) fits=20 > vertically on the page, but which is too wide for the text=20 > column. So I decrease the width of (any) one of the columns=20 > so that the table fits horizontally. Doing so causes the=20 > table to immediately jump to the next page, leaving a huge=20 > gap on the original page. However, reducing the column width=20 > had no effect on text-wrapping within the table, so its=20 > height remains unchanged.=20 >=20 > I then tried inserting a page break into the table to try to=20 > get it to fit vertically. But even if I do so only a few rows=20 > (about 3cm) from the top of the table, the preceding rows=20 > remains stubbornly on a page all of their own. Thsi rings a vague bell but I'm somewhat tied up right now. You might find something if you check the archive for 2001 and 2002 (there isn't all that much on Frame), on the old Yahoogroups list of course. I'll have a think over the weekend. You;ve tried saving as mif and relaunching, have you? ************************************************** To post a message to austechwriter, send the message to austechwriter@xxxxxxxxxxxxxx To subscribe to austechwriter, send a message to austechwriter-request@xxxxxxxxxxxxx with "subscribe" in the Subject field. To unsubscribe, send a message to austechwriter-request@xxxxxxxxxxxxx with "unsubscribe" in the Subject field. To search the austechwriter archives, go to www.freelists.org/archives/austechwriter To contact the list administrator, send a message to austechwriter-admins@xxxxxxxxxxxxx **************************************************