atw: Re: Urgent FrameMaker problem

Thus are legacy problems born. That's a real hack that should be avoided. 

Cheers.

Bruce Ashley





> -----Original Message-----
> From: austechwriter-bounce@xxxxxxxxxxxxx
> [mailto:austechwriter-bounce@xxxxxxxxxxxxx]On Behalf Of Naomi Kramer
> Sent: Friday, 25 June 2004 4:46 PM
> To: austechwriter@xxxxxxxxxxxxx
> Subject: atw: Re: Urgent FrameMaker problem
> 
> 
> If it's something you need to do ASAP, and a temp hack job 
> will do for 
> now... take a screenshot of the table and add it to the doc as an 
> image?
> 
> - Naomi
> 
> > In FrameMaker 6 on Windows, I have a table that (easily) fits
> > vertically on the page, but which is too wide for the text 
> column. So
> > I decrease the width of (any) one of the columns so that the table
> > fits horizontally. Doing so causes the table to immediately jump to
> > the next page, leaving a huge gap on the original page. However,
> > reducing the column width had no effect on text-wrapping within the
> > table, so its height remains unchanged. 
> > 
> > I then tried inserting a page break into the table to try 
> to get it to
> > fit vertically. But even if I do so only a few rows (about 3cm) from
> > the top of the table, the preceding rows remains stubbornly 
> on a page
> > all of their own.
> > 
> > Please, what can I do to make the table fit on the original page?
> > 
> > Thanks,
> > Craig 
> 
> **************************************************
> To post a message to austechwriter, send the message to 
> austechwriter@xxxxxxxxxxxxxx
> 
> To subscribe to austechwriter, send a message to 
> austechwriter-request@xxxxxxxxxxxxx with "subscribe" in the 
> Subject field.
> 
> To unsubscribe, send a message to 
> austechwriter-request@xxxxxxxxxxxxx with "unsubscribe" in the 
> Subject field.
> 
> To search the austechwriter archives, go to 
> www.freelists.org/archives/austechwriter
> 
> To contact the list administrator, send a message to 
> austechwriter-admins@xxxxxxxxxxxxx
> **************************************************
**************************************************
To post a message to austechwriter, send the message to 
austechwriter@xxxxxxxxxxxxxx

To subscribe to austechwriter, send a message to 
austechwriter-request@xxxxxxxxxxxxx with "subscribe" in the Subject field.

To unsubscribe, send a message to austechwriter-request@xxxxxxxxxxxxx with 
"unsubscribe" in the Subject field.

To search the austechwriter archives, go to 
www.freelists.org/archives/austechwriter

To contact the list administrator, send a message to 
austechwriter-admins@xxxxxxxxxxxxx
**************************************************

Other related posts: