If the set is completely dead ( check cr14106 at output of power supply for around 140 volts), If missing check for open R14103 1 meg 1/4 watt in primary of supply. This comes off the raw B+ supply for the kick to start the circuit. Darrell Loeffler Mountain Tv & Video Waynesville,NC [TechAssist] rca tv ctc203ax1 "dead set" need schematic. Date: 2/18/02 2:39:53 PM Eastern Standard Time From: weavel@xxxxxxxx (joe weaver) Sender: techassist-bounce@xxxxxxxxxxxxx Reply-to: techassist@xxxxxxxxxxxxx To: techassist@xxxxxxxxxxxxx (tech assist) hello everyone, the fuse is good . no relay action.. i resoldered a lot of bad connections i could find...i dont have any service info on this chassis so i dont know where any of the voltage readings are suppose to be taken..any help would be appreciative... thank you....joe ps:this is the first time working on this chassis.without a manual i couldnt provide much info..so please dont flame me to bad.. thanks... william j.weaver weavers electronics 268 w.water st. oak harbor,ohio 43449 1-419-898-4129 phone 1-419-898-5054 fax "God Bless America" ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.