[TechAssist] Re: Zenith TV SD5729W mod. 9-519-1 -touch pad doesn't work
- From: "Bob@Bobs tv" <woodman1@xxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Sat, 26 Feb 2005 16:03:36 -0500
Gary,
That is held on double sided tape, remove and it destroys NLA.. Have
caused a lot of problems.. If the infra sensor is not on that panel you can
unplug ribbon cable and operate with remote../.
Bob,
Bobs TV Worcester, ma
woodman1@xxxxxxxx
Main 508-853-1482
Fax 508-853-1480
----- Original Message -----
From: "Gary McCartney" <gary@xxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Friday, February 25, 2005 10:39 PM
Subject: [TechAssist] Re: Zenith TV SD5729W mod. 9-519-1 -touch pad doesn't
work
> Max, I'm not sure we are talking about the same part here. I am asking
> how to get the touch pad apart on the flip down door.
>
> Here is a pic of it:
>
> http://www.number63.ca/zenithdoor.jpg
>
> Do you have one like it? I'm not familiar with these. Is it the touch
> pad that is most likely the problem, or is data on the main board not
> getting to the micro a common thing?
>
>
>
>
> Gary McCartney
>
> McCartney Electronics
> Guelph Ontario Canada
> Est. 1984
> email: gary (at) number63.ca
>
>
>
>
>
>
>
>
> Old TV Man wrote:
> > Gary - that control board should come out after removing 2 or 3 screws
> > frim the back. It should also have a part # on it.
> > I have some of he old control boards if you find the #.
> >
> > Max Bonnell
> > Bonnell TV
> > Robinson, IL
> >
> > Sender: techassist-bounce@xxxxxxxxxxxxx From:
> > gary@xxxxxxxxxxx(Gary=A0McCartney) Date: Fri, Feb 25, 2005, 3:50pm
> > (CST+1) To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Zenith TV
> > SD5729W mod. 9-519-1 -touch pad doesn't work Reply=A0to:
> > techassist@xxxxxxxxxxxxx
> >
> > I have this Zenith TV SD5729W with module 9-519-1. The touch pad inside
> > the pull down door on the front doesn't work. Set won't start and none
> > of the buttons work. I can operate the set with a universal remote
> > although it seemed like I could only raise the volume a bit and max.
> > level is low.
> >
> > Customer said that someone let water run into TV. He wasn't sure if it
> > was down the face of the tube or not. I haven't seen any sign of water
> > in the set.
> >
> > Is there any way to clean the keypad contacts? If so, how do you even
> > remove the door to work at it or take the keypad apart? Or is there more
> > likely a problem on the board leading to the micro?
> > Thanks for any help.
>
>
> --------------------------------------------------------------------------
---
> Lost Password:
> http://www.tech-assist.org and select "Login Problems?".
> Email Archives:
> //www.freelists.org/archives/techassist/
>
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/
Other related posts:
