Gary - that control board should come out after removing 2 or 3 screws frim the back. It should also have a part # on it. I have some of he old control boards if you find the #. Max Bonnell Bonnell TV Robinson, IL Sender: techassist-bounce@xxxxxxxxxxxxx From: gary@xxxxxxxxxxx(Gary=A0McCartney) Date: Fri, Feb 25, 2005, 3:50pm (CST+1) To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Zenith TV SD5729W mod. 9-519-1 -touch pad doesn't work Reply=A0to: techassist@xxxxxxxxxxxxx I have this Zenith TV SD5729W with module 9-519-1. The touch pad inside the pull down door on the front doesn't work. Set won't start and none of the buttons work. I can operate the set with a universal remote although it seemed like I could only raise the volume a bit and max. level is low. Customer said that someone let water run into TV. He wasn't sure if it was down the face of the tube or not. I haven't seen any sign of water in the set. Is there any way to clean the keypad contacts? If so, how do you even remove the door to work at it or take the keypad apart? Or is there more likely a problem on the board leading to the micro? Thanks for any help. -- Gary McCartney McCartney Electronics Guelph Ontario Canada Est. 1984 email: gary (at) number63.ca ---------------------------------------------- ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/