[TechAssist] Re: Zenith TV SD5729W mod. 9-519-1 -touch pad doesn't work
- From: gulftech@xxxxxxxx
- To: techassist@xxxxxxxxxxxxx
- Date: Fri, 25 Feb 2005 22:22:28 -0600
Gary,
I haven't worked on one of those for a LONG time, but the problem (as I
remember) is with the cable from the control board to the pcb.
Replacement of the board and cable is the only solution I know of.
I did work for a rental company many years ago and replaced a ton of
them. Max may well have what you need. You remove the door and
disconnect the ribbon cable from the chassis.
Ken Smith
Gulf Technical Services
3034 Gulf Breeze Parkway
Gulf Breeze, FL 32563
850-934-8324 (Voice), 850-932-0819 (fax)
On Fri, 25 Feb 2005 22:39:45 -0500 Gary McCartney <gary@xxxxxxxxxxx>
writes:
> Max, I'm not sure we are talking about the same part here. I am
> asking
> how to get the touch pad apart on the flip down door.
>
> Here is a pic of it:
>
> http://www.number63.ca/zenithdoor.jpg
>
> Do you have one like it? I'm not familiar with these. Is it the
> touch
> pad that is most likely the problem, or is data on the main board
> not
> getting to the micro a common thing?
>
>
>
>
> Gary McCartney
>
> McCartney Electronics
> Guelph Ontario Canada
> Est. 1984
> email: gary (at) number63.ca
>
>
>
>
>
>
>
>
> Old TV Man wrote:
> > Gary - that control board should come out after removing 2 or 3
> screws
> > frim the back. It should also have a part # on it.
> > I have some of he old control boards if you find the #.
> >
> > Max Bonnell
> > Bonnell TV
> > Robinson, IL
> >
> > Sender: techassist-bounce@xxxxxxxxxxxxx From:
> > gary@xxxxxxxxxxx(Gary=A0McCartney) Date: Fri, Feb 25, 2005, 3:50pm
> > (CST+1) To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Zenith
> TV
> > SD5729W mod. 9-519-1 -touch pad doesn't work Reply=A0to:
> > techassist@xxxxxxxxxxxxx
> >
> > I have this Zenith TV SD5729W with module 9-519-1. The touch pad
> inside
> > the pull down door on the front doesn't work. Set won't start and
> none
> > of the buttons work. I can operate the set with a universal remote
> > although it seemed like I could only raise the volume a bit and
> max.
> > level is low.
> >
> > Customer said that someone let water run into TV. He wasn't sure
> if it
> > was down the face of the tube or not. I haven't seen any sign of
> water
> > in the set.
> >
> > Is there any way to clean the keypad contacts? If so, how do you
> even
> > remove the door to work at it or take the keypad apart? Or is
> there more
> > likely a problem on the board leading to the micro?
> > Thanks for any help.
>
>
>
-------------------------------------------------------------------------
----
> Lost Password:
> t.org and select "Login Problems?".
> Email Archives:
> //www.freelists.org/archives/techassist/
>
>
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/
Other related posts:
