get a different 9-1674 Module Exchange in Duncanville,Tx (Dallas) 972-296-1212 they only rework Zenith modules and are good at it Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Larry E" <videotech@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, April 07, 2005 11:50 AM Subject: [TechAssist] Zenith RZ56Z83D8 9-1674 tubes die at scene change > Hi Guys, this Zenith RZ56Z83D8 shuts down the tubes on bright scenes/scene > change, original complaint was dead, changed 9-1674 module, convergence module > 9-1690 failed 20 minutes after installing 9-1674, replaced STK`s, had no 16 v line, > found open winding on flyback, replaced fly, now G2 is too high, turn control all > the way counterclockwise red & green still lit, set jumpers to disable, turned up > each tube to retrace and then back down to extinguish retrace, replaced jumpers > to normal mode and tubes come on very bright, and instantly go out, set > has a good picture when it`s running but obviously X-Ray protect is shutting the tubes > off, any ideas or should I buy another 9-1674? Needless to say customer is > very pissed off at this point, your help is appreciated, Larry E > Larry Eastman > American TV & Electronics > Crystal River, Fl. 34428 > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/