Start checking caps around jungle IC. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Webster TV" <webstertv@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, February 13, 2004 3:26 PM Subject: [TechAssist] Zenith 35" or 36" console, 9-1096 main module, 9-1093 smps/sweep > Techs, > > I have this monster of a console in the shop that has a intermittent fast > vert. flip or roll. I've replaced the vert. output chip and also CR2102 > diode in the vert circuit as of a tip from the Zenith tips site, but still > have the same problem. Occasionally it will straighten out for a minute or > so and then right back to the flipping, everything else looks OK when it > stops, its not stretched or no overlap or retrace lines. Anyone seen this on > this chassis or have a solution, before I dig deeper? I don't have the > schematic for this unit, and the tag is gone off of the back of the set, > although I did find #ZB3551T7 (manufactured in 1992) stamped inside, not > sure if this is the model # or not? > > TIA > Dan Webster > Webster's TV > Shullsburg, Wi. > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/