Bruce, found a couple tips for various XBR sets for width problems KV27XBR96S Excessive Width Q506 872901100 (2SK1916) & Q513 872914096 (2SD774-34) KV27XBR35 width excessive bowed pix (pincushion replaced Q516 in pin circuit) Gary McCartney McCartney Electronics Guelph Ontario Canada Est. 1984 email: gary (at) number63.ca Bruce Tiedeman wrote: > The picture deflection is over scanned and the power supply has low B+ > voltage. Looks like and open capacitor some where. > > The picture is full ,Overscanned top and bottom and sides. The collector B+ > is 108 volts and 871 PPVolts. I checked the power supply caps OK. I removed > the supply and checked the B+ is low with it removed from chassis. You would > think the deflection would be reduced with low B+ . Before I check the caps > in the horiz section thought I would see if any one has seen this before. > thanks > Bruce. > > B&T Electronics > 139 Margaret St > Sarnia Ontario > Canada > N7T 2Y3 > 519 344 1850 > > > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/