Did you try removimg the neck pcb, load the anode w/ a HV probe? Sometimes a bad CRT will do that. Jim McVey McVey Alltronix 327 Broadway Newburgh Ny 12550 ph: 845 561 8383 fx: 845 561 9017 Consumer electronics & computer service. Factory authorized for over twenty brands. ----- Original Message ----- From: "Peter oliver" <oliver_peter1@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, April 20, 2004 3:41 PM Subject: [TechAssist] Sharp 32U-S50B Dead > Sharp > 32u-s50b > mfd 2003 > Set is in a dead/shutdown condition. B+ at collector of HOT > is only ~120v. When power is pushed set will click then click off again > after ~ 6 sec. Flyback rings ok (~70 rings on sencore). Have the schemaic. > And the discusion goes on about pittifel equipment only a year old. > Any one run into this before? > > Peter Oliver > Tucson Radio TV > > _________________________________________________________________ > Watch LIVE baseball games on your computer with MLB.TV, included with MSN > Premium! > http://join.msn.com/?page=features/mlb&pgmarket=en-us/go/onm00200439ave/direct/01/ > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/