[TechAssist] Re: Sanyo 27 in TV Model 62C852U need value for R628

  • From: Eric Manuel <tvman@xxxxxxxxxxxxxxx>
  • To: techassist@xxxxxxxxxxxxx
  • Date: Sat, 22 May 2004 10:33:32 -0230

Hi Fernand is there a chassis# and where is the resister located I may a
have a diagram similer..Eric
E M Electronics
Deer Lake Nfld
Eric Manuel

FERNAND GOGUEN wrote:
> 
> I am still fighting this beast. I contacted Sanyo and was told that R628
> (R608) was a 680 ohm 2 watt resistor. I replaced it and as soon as I apply
> power the resistor starts to smoke. I checked and I have 167 volts on one
> side and 85 volts on the other side. I checked all transistors , diodes ,
> caps and find no shorts.
> Does any one have a print that they couls email me? I would appreciate it.
> Fernand Goguen
> Goguen TV Service
> Cocagne, N.B. CANADA
> ----- Original Message -----
> From: "John at Main TV" <maintv2004@xxxxxxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Wednesday, April 21, 2004 1:37 PM
> Subject: [TechAssist] Re: Sanyo 27 in TV Model 62C852U need value for R628
> 
> > I do not have that manual but the US version of that model is AVM252
> (manu.
> > 1990) and is in Sams 2837-2.  Maybe someone has that manual that they
> could
> > e-mail.  However, assuming my model cross is correct, I could not find a
> > R628.  There is a R608 that is a 680 ohm 2 watt that goes from +160 volt
> > source to the collector of the audio out.  Can you tell if this resistor
> is
> > in the audio circuit?   John.
> >
> > John Mielke
> > Main TV
> > 636 main St.
> > Longmont, Co
> > phone 303 776 6955
> > fax  303 776 0792
> > maintv2004@xxxxxxxxxxx
> > ----- Original Message -----
> > From: "FERNAND GOGUEN" <fgoguen@xxxxxxxxxxxxxxx>
> > To: <techassist@xxxxxxxxxxxxx>
> > Sent: Tuesday, April 20, 2004 3:32 PM
> > Subject: [TechAssist] Sanyo 27 in TV Model 62C852U need value for R628
> >
> >
> > > I could use a scan for the above tv. Came in dead and upon inspecting
> the
> > chassis found this resistor burned almost to a crisp. The ckb under this
> > resistor is all black and the solder pads where this resistor connects are
> > all broken.
> > > Chassis # G3E-852U1.  TIA
> > > Fernand Goguen
> > > Goguen TV Service
> > > Cocagne, N.B. CANADA
> > >
> >
> > --------------------------------------------------------------------------
> > ---
> > > Lost Password:
> > > http://www.tech-assist.org  and select "Login Problems?".
> > > Email Archives:
> > > //www.freelists.org/archives/techassist/
> > >
> >
> > --------------------------------------------------------------------------
> ---
> > Lost Password:
> > http://www.tech-assist.org  and select "Login Problems?".
> > Email Archives:
> > //www.freelists.org/archives/techassist/
> 
> -----------------------------------------------------------------------------
> Lost Password:
> http://www.tech-assist.org  and select "Login Problems?".
> Email Archives:
> //www.freelists.org/archives/techassist/

-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org  and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/

Other related posts: