Sounds like the thermal fuse inside the gear shift solenoid is open. The solenoid can be seen from the top on the right side of the take-up reel. Should measure about 18 ohms if OK. If it is OK the solenoid lever return spring could be off or missing. Solenoid problems are usually caused by mode switch/ mechanical alignment problems. Jerry Silverman Greentron Inc 4 Newland Ave Greenville SC 29609 864 232 3889 Fax 271 2080 mailto:greentron@xxxxxxx ----- Original Message ----- From: "Wally Heise" <sirepair@xxxxxxxxxx> To: "Tech Assist" <techassist@xxxxxxxxxxxxx> Sent: Monday, March 08, 2004 11:02 PM Subject: [TechAssist] RCA VCR Model VR480 - ejects tape > I have a customer that wants this older vcr fixed. Originally came in with > bad power supply, I fixed that with capacitors, etc. > > Now the problem is: > Insert tape, capstan motor continues to run for a few seconds but the clutch > doesn't move, something is locking it up. The head never starts turning or > the guide post assemblies never move and pull the tape out. After a few > seconds, the tape is ejected. The center led and end sensors are OK. > > With no manual, it is difficult to visualize what levers move, etc. Any > help would be appreciated on what I should look at. > > Thanks, > Wally Heise > South Isle Repair > Isle, Mn. > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/