Hello all Is there any alternative to buying a $75.00 service manual to get a schematic? I have a chassis on the bench that might need a microprocessor, but I want to trouble shoot it a little better first.I do have a pulse at pin 5 on the eprom with 1.5 volts dc there and I don't know if that's the clock or data line., and can see a very weak pulse on pin 6 of eprom with 2.3 volts there. I scraped the glue from under caps 503 & 581 on the convergence board, thinking that might be holding the data line down.There is only .52 volts at the black wire at P19503, and .48 volts on the white wire there.I also have 4.9 volts at one of the pins on the micro. I do have 140 volts at the hot across a 40 watt light bulb for test load. Any help is appreciated Richard La Placa Continental TV Chestertown, MD,21620 Fax# 410-778-1113 continentaltv@xxxxxxxxxxx ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/