Replace the mixer/oscillator chip with that symptom..... Bill Grabowski Triangle Appliance Kenosha,Wi 53142 daryls_tv@xxxxxxx wrote: > Hi, > This RCA, model # G27304DT, ch. CTC177AM2, is really kicking my behind. > It started with the complaint from the customer of losing some channels with > lines in the picture. I pulled it into the shop and did the usual tuner > re-soldering job. Set looked great and was delivered only to find out it was > doing the same thing. Took it back to the shop where it worked great. I > re-soldered everything again plus all of the connections on the smds. > Delivered it again and you guessed it...same thing. > The channels from 40 through 50 were either missing or full of lines or motor > boating. I played with some of the tuner parameters and it seemed to work > but not to my satisfaction. The customer was pleased, so I left. A week > later, same thing. > I pulled it back to the shop where it worked fine. BTW... the customer has > another set that works fine on the same cable line. I put an attenuator on > my cable line and the trouble showed up and even worse. It gave me channels > 2-6, 18-22, and 40-50 with the problems. I re-soldered every smd in the > video section besides the tuner again and all of the grounds in the set... no > help. Looked with a high power magnifier for cracks in the print (none > found). Replaced IC7301, C7414(cracked), CR7102(didn't check the same as the > others), Q7102(RF amp), U3201(eeprom), & U1001(t-chip). Did the tuner > alignments after each parts change but still no joy. I found that if I would > place my finger over coils L7114 & L7112, the set would start to function > properly. I got the same effect placing my finger over L7115, L7113 & L7111. > I didn't have to touch the coils, just put my finger near the coils. This > symptom reminds me of the old tube days when the grid neutralizer trimmer cap > wa s o > ut of adjustment on the RF amp tube. > I really hope someone has encountered this and has a cure.... Help!! > Sorry for the long post but I deemed it necessary to explain the problem. > Thanks, > Daryl > Daryl's TV > 2402 Wyoming Ave. > El Paso, TX 79903 > 915-565-9184 Voice/Fax > daryls_tv@xxxxxxx > www.angelfire.com/tv2/daryls_tv > > -- ***************************** Bill Grabowski Triangle Appliance Kenosha,Wi 53142 262-694-6500 262-694-6523 fax bgrabowski@xxxxxxxxx ***************************** ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/