Walt, This is from an RCA service bullion: Symptom: The tuner cannot be aligned correctly using the XX15053-470 microprocessor built in service mode. Cause: An error in the microprocessor code causes the incorrect value to be stored in the EEPROM when the alignment is made using the built in service mode. Cure: If the microprocessor is marked XX15053-470, use Chipper Check software to align the tuner. If the microprocessor is marked XX15053-47A, the built in service mode should align correctly. I don't know if this problem would affect alignments other than tuner, but it may. Hope this helps. Jerry Christians Electronic Service ----- Original Message ----- From: <Wallyusmc1@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, March 09, 2002 10:28 AM Subject: [TechAssist] RCA F25216WT, CTC185AB, won't hold memory | | | Hi all, | This set will not hold memory for vertical adjustment. When I reset the | vertical value the picture fills the screen properly, however, when I exit | the menu, the vertical is down about 4 inches at the top. Changed EEPROM-no | luck. Could this be a jungle problem? TIA. | Walt | | | Walt Chambers, LtCol, USMC (Ret) | Walt's TV/VCR Service | 3753 Mission Avenue, STE 117 | Oceanside, CA 92054 | Ph 760-966-1213 | Fax 760-966-0891 | Mailto:wallyusmc1@xxxxxxx | ------------------------------------------ | Make your TechAssist database better! | Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ | ------------------------------------------ | To UNSUBSCRIBE your email address, click here: | mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe | Or send a BLANK email with unsubscribe in the | SUBJECT field to the address above. | ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.