You probably have some geometry adjustment that is slightly out, do the geometry alignment first then see if the auto convergence works. The Old Master Technician ******************************** Since 1972 * Jim Myers * Telrad Electronics * Fort Wayne Indiana * ******************************** Valley TV wrote: > Hi Everyone.. "Another" week.. > I encountered a problem with a D52W20YX1 (ATC221) that > I have not run into before. Poor convergence in the > bottom left side was apparent as I walked in the door. > I expected to find a problem on the convergence circuit > board and was surprised that everything tested fine.=20 > I accessed the factory menu and found the green was out > and was really surprised that it adjusted perfectly. > I saved my settings & then ran the sensor setup & was > once again surprised that the screen flashed RED > instead of green when it completed. I thought maybe > my memory was wrong & red was the color the screen > DID flash at the end but... I exited the factory menu > & shut the set off. Convergence was perfect when=20 > restarted & I left it heat up 15 minutes then started > the customer autoconvergence feature.. Hmmm. Unit only > started the procedure for 8-9 seconds and quit.. Seemed > to do it on red & did no "damage" to the convergence but > customer was not happy. I ran it a few times and SOMETIMES > it went through the whole procedure but usually stopped > in the first 8 seconds.. I'm frazzled.. Any thoughts?? > > TIA!!!! > > Gary > Valley TV > Drums, PA office > > > --=20 > ___________________________________________________ > Play 100s of games for FREE! http://games.mail.com/ > > ----------------------------------------------------------------------------- > This Email List is accessible to the general public through search engines. > Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/