Bill, check each of your crt leads going into that new splitter! I just repaired one and had the arching and it was because one of my leads had bent over and was not making good contact. I cut off ends of leads striped back insular and seated them correctly. Cleared up my problem. Hope this helps you. Terry Bill S wrote: > > Hi all > This unit came in dead with the HOT shorted as well as C4402 blown (bulge in > middle and changed values) and CR4402 shorted. I replaced all three shorted > parts and turned the set on. The set came up without any high voltage and > ticking coming from the splitter. I disconnected the high voltage lead from > the flyback to the splitter and the ticking went away. I replaced the > splitter unit and now I have high voltage and picture but the ticking is > still occuring and there is arcing in the picture. Are there more parts > that are going bad in the HOT circuit thereby causing excessive high > voltage. I am not sure if I am reading the high voltage right. It says 30 > KV but it seems to be fluctuating a bit too. > Thanks > Bill Sorensen > New Life Video & Audio > billans@xxxxxxxxxxxx > - - - - - - - - - - - - - - - - - - - > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.