I replaced CR4118, C4145 the 2.2mf, 15mf, 47mf around U4101 and the B+ in the standby mode reads 160v and it still will not come on. And by the way this is a 27" TV not PTV. At 04:32 PM 5/13/03, you wrote: >Mark: > >Check or change c4402 and cr4402. > >or > >CR4118 is a very common problem (15 volt line). CHANGE CR4118 (even if >it checks "okay") and also change it's filter capacitor (I think it is >C4145). Then see what else you have after that. It may just be that >simple! > >or > >Also check or replace the 2.2uf and 15uf and 4.7 (or 3.9uf) caps >situated around U4101? >Those control your B+ which should be 143v with TV turned >off, but plugged in (standby mode). > >or > >Try removing the HV lead from the bleeder assy. If it runs and you have >about 30kv coming out of the IHVT, plug >it back in and disconnect all three HV leads to the CRTs. If the bleeder is >ok start rehooking tubes one at a time till the culprit shows up. (Bleeder >might be bad) > >or > >What is happening at the fault detector input of the CPU? U3100(2). This >should >be at least 3.7 volts. > >or > >Unsolder b+ to audio final(S), or just pull audio final(S), if set starts up >then they are shorted. They will cause set to pulse 3 times if they are >shorted. > >Perry Bower, (EHEER) Electronic Home Entertainment Equipment Repairer >Electric Medic >"It's Cheaper to Keep Her" >http://www.electricmedic.com >Free Electronic Screensaver: >http://www.eyetide.com/download/?s=O3OfmSLHXygGHCv1W6Gz3Bgjtq3DNNMNdcKsYSVGC >3850 Washington Road Suite 5b >Augusta, Georgia 30907 >Phone: 706-8MEDIC4 (863-3424) >Phone: 706-863-3474 >Fax: 706-863-2316 >mailto:info@xxxxxxxxxxxxxxxxx > > >-----Original Message----- >From: techassist-bounce@xxxxxxxxxxxxx >[mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of >ElectronicRepair@xxxxxxxxxxx >Sent: Tuesday, May 13, 2003 4:22 PM >To: techassist@xxxxxxxxxxxxx >Subject: [TechAssist] Proscan TV Model # PS27151 CTC169CE > > >TV came in dead, checked and found the HOT shorted and the main 5amp fuse >open, replaced the HOT and the fuse, now I have B+ on the collector of the >HOT but it still will not turn on. Any suggestions will be appreciated > > >Thank you, Mark >Electronic Repair Services >48 W. James St. >Lancaster, PA 17603 >Phone 717-393-5115 >FAX 717-393-5115 > >**************************************************************************** >* >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.html >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.html >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ > >***************************************************************************** >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.html >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.html >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ Thank you, Mark Electronic Repair Services 48 W. James St. Lancaster, PA 17603 Phone 717-393-5115 FAX 717-393-5115 ***************************************************************************** The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.html Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.html Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/