According to WinsTips 2.0 If has Bright raster w/ retrace and then shuts down: -Open R58 22ohm On Crt Board And Cold Solder At R384 (Surface Mount On Main Board) -If R58 Open, Check For Shorted Ic50, Ic51 & Ic52 Pin 4 To Ground. -Check R9 (22ohm) On Crt Panel -R508 22 Ohm On Crt Module Open Dan Garris dgarris@xxxxxxxxxxx Garris TV New Bern, nC >From: larry <schntv@xxxxxxxxxxxx> >Reply-To: techassist@xxxxxxxxxxxxx >To: techassist@xxxxxxxxxxxxx >Subject: [TechAssist] Phillips 25B800 , shut down, need schematic >Date: Mon, 09 Aug 2004 16:38:11 -0400 > >phillips 25b800, had no vertical, >I cant seem to find a schematic of the crt board for this chassis. >replaced vert ic, > rectifier, resistor, 2 electrolytics. >comes on for 4 seconds then shutdown. >too much screen drive. >white with retrace. >adjusting screen control is very sensitive. >can a shorted vert. cause video damage? >Thank you, >Larry > >-- >Schneider TV & Electronic Inc. >5415 N. Wooster ave. >Dover, Ohio 44622 www.geocities.com/schntv2000/ >330-343-0768 FCC. first class & Extra class K8WLY > > >----------------------------------------------------------------------------- >Lost Password: >http://www.tech-assist.org and select "Login Problems?". >Email Archives: >//www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/