This is a compact table top projection set. Cute. Chassis pulls out. Push power, just a click. Customer said after a storm (that took out other things in the home) this set was dead. On the power supply board I found one pico fuse open: F9A05, a 5 amp fusing the negative (-) 24 volt source. This supplies negative voltage to the two convergence IC's IC8C01 and IC8C02, both STK392-110 on another board. Nothing else "seems" bad except the fuse. Would you replace the two converg. STKs as well? (- )24VDC source runs as follows: smps transformer pin 22 to F9A05, to diode D9A61, filtered by caps C9A72 and C9A73 both 330uF@35V, and exiting at edge connector "KF" pin 15,16, coupling the power board to the deflection board where the STK392-110's live. All the lo-ohm fuses near STKs are OK, no diodes seem bad. Phil Bader -- Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/