I am inquiring for another Service shop,.. His original complaint was Power up, shuts back down in about 20 seconds. I suggested for him to check the vertical, and of course the Vertical O/P IC was shorted. He replaced it, then had a raster for about 2 minutes, and Vertical O/P shorted again. I asked him if he had changed any caps in the vertical and he said he had changed 4. If he disconnects the vertical connection on the Yoke it will not shut down. I supected yoke, but apparently although not epoxied on, yoke and CRT are listed under one Part Number. Has anyone had problems with taking out Vertical O/P IC shortly after turn on. He claims he has a full vetical raster while the set is running. -Ed- Tel-Tek Electronics Ontario-Canada teltek3@xxxxxxxxxxxx ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/