If you use a Crosshatch pattern in the Video one mode are the sides, top and bottom rouind or are they Ok? Tommy R Herman Herman TV 250 School Ave SW Taylorsville NC 28681 828-632-5322 Voice 828-632-3880 Fax www.hermantv.com hermantvr@xxxxxxxxxxxxx Have Hitachi HDTV 43FDX01B, came in with bad convergence-replaced both conv. chips (STK392-110 put in Hitachi chips) 2.2 ohm resistor open on one return line in conv. yoke circuit. Convergence now looks ok, but now have three seperate red, blue, and green curved lines over the pix at the top of raster. Problem shows up in aux. video input also. Put in new digital convergence module--still same problem. Nothing found on Hitachi service web site. Set made in 2000. Nothing on Winstips. Theses 3 colored curved lines are about 8-10 in. across. Has anyone seen this problem in Hitachi? Cutomer wants TV back for Christmas. -- Hugh Thornley Main TV 636 Main St. Longmont, Colorado 80501 303-776-6955 ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/