Did you check the caps in the vertical circuit? George Afana Electronics Moreno Valley, CA ----- Original Message ----- From: "Hugh at Main TV" <maintv@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, December 18, 2003 2:50 PM Subject: [TechAssist] Hitachi HDTV--different problem-PTV > Have Hitachi HDTV 43FDX01B, came in with bad convergence-replaced both > conv. chips (STK392-110 put in Hitachi chips) > 2.2 ohm resistor open on one return line in conv. yoke circuit. > Convergence now looks ok, but now have three seperate red, blue, and green > curved lines over the pix at the top of raster. Problem shows up in aux. > video input also. Put in new digital convergence module--still same > problem. Nothing found on Hitachi service web site. Set made in 2000. > Nothing on Winstips. Theses 3 colored curved lines are about 8-10 in. > across. > Has anyone seen this problem in Hitachi? Cutomer wants TV back for > Christmas. > > -- > Hugh Thornley > Main TV > 636 Main St. > Longmont, Colorado 80501 > 303-776-6955 > maintv@xxxxxxxxxxx > > > > **************************************************************************** * > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/