First check that your 5 volt supply to the Micro is 4.8 volts or higher, if ok then replace Microprocessor. BTW since this is a spacemaker, make sure ALL your shields are in place and properly soldered. Damon Brunger damon101@xxxxxxxxxxxxxx Telrad Electronic Services Ft Wayne, IN 46815 ----- Original Message ----- From: <HSWAD@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, February 09, 2002 9:34 AM Subject: [TechAssist] GE Spacemaker TV Model 7-7690 goes crazy > > This TV when first turned on works perfect including remote control > operation. After about an hour or so it will change to the next highest > number channel then after a bit will go to the next higher channel. After a > bit more time will end up changing back and forth constantly between the two > highest number channels that have been programmed in. A short while later it > will no longer be responsive to any pushbutton control or remote function. > Unplug it, wait five minutes, and it is ready to work perfectly until the > trouble starts all over again. Any ideas?? Hollis Bates > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.