Hi Jeff: I would use the GLYPTOL, it never fails. Barry barrystv@xxxxxxx Barrys TV 613 224 3406 Ottawa Canada ----- Original Message ----- From: "Jeff Dougherty" <support@xxxxxxxxxxxxxxxxxx> To: "Techsonline" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, November 19, 2002 10:29 PM Subject: [TechAssist] Re: Final update. P46770CK PTV169: Bad FBT > > After trying two new flybacks and a used one from a direct view set, they all > fried the R4762U. > I am putting the old flyback in with the pinhole sealed with silicone. > Ran the set for hours this way, no problem. Resistor doesn't even get warm. > It appears these new flybacks may be OK for direct view sets, but not this > projection set. > Thanks to the many of you that sent suggestions and attachments. > > Jeff > > FAX 717-564-4952 > Jeff Dougherty > Intrepid Video & Electronics Be careful of your thoughts. > 501 Luther Rd They may become your words > Harrisburg, PA 17111 any moment. > 717-909-8844 > VCR tips, electronics info & general interest. > www.intrepid-video.com www.tech-repair.net > www.thetoolcaddy.com www.9-11-2001tragedy.com > *********************************************************************** > > > > Unit came in with HOT shorted, found IHVT with a pin hole in it arcing to the > metal shield for the AC plug. > I repaired the hole to verify nothing else was wrong with the unit before ordering > a flyback. Unit ran for a few minutes. > Order FBT from Tritronics #232191 which is a new part. > After installing new part, unit would not turn on for a few seconds, then R762 on > power board started to smoke...or at least smoke came from this direction. I > quickly turned of the variac. > I replaced the FBT I had repaired, and now unit only clicks numerous times after > pressing power, press power again and stops clicking. > R762U reads about 1.2K, but color code appears to be yellow, black and third band > is burnt. > I have no print. > So, either I got a bad flyback or this was not the right part number? > Any suggestions? > > Jeff > > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/