There's a 100uf @25volt cap right next to the chip that you replaced. Give that a try. I have had them bad info wrote: >Well, posibly touch a connector to ground.... and now the B+ is low, about >67 Volts....but power on and sound is high, the video is reduced like a >regulator bad. They have 2 mosfet to reg 115 v and other voltages. I check a >lot of protection and fuses and all is ok, really have my head confuss. >Ruben >----- Original Message ----- >From: "Shaun" <ssroark@xxxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Sent: Saturday, March 16, 2002 6:53 PM >Subject: (Archive Copy) [TechAssist] Re: Zenith A50M91W9 > > >>Make sure none of the screws feel into the chasis if all you did was clean >>it. >> >>Shaun >>Advanced Electronics >>Fort Morgan, CO 80701 >>(970)867-3124 >>ssroark@xxxxxxxx >>----- Original Message ----- >>From: "info" <info@xxxxxxxxxxxxx> >>To: <techassist@xxxxxxxxxxxxx> >>Sent: Saturday, March 16, 2002 3:20 PM >>Subject: [TechAssist] Zenith A50M91W9 >> >> >>>This unit was open to clean the mirror, after that the power supply just >>>give 60 Volts (maybe some short circuit?)......I check the regulator and >>> >>ok, >> >>>change a MC34065P but dont start up with new circuit. Any help is very >>>appreciated. >>>Ruben V. >>> >>> >>>------------------------------------------ >>>Make your TechAssist database better! >>>Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >>>------------------------------------------ >>>To UNSUBSCRIBE your email address, click here: >>>mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >>>Or send a BLANK email with unsubscribe in the >>>SUBJECT field to the address above. >>> >>------------------------------------------ >>Make your TechAssist database better! >>Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >>------------------------------------------ >>To UNSUBSCRIBE your email address, click here: >>mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >>Or send a BLANK email with unsubscribe in the >>SUBJECT field to the address above. >> >> >> > > >------------------------------------------ >Make your TechAssist database better! >Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ >------------------------------------------ >To UNSUBSCRIBE your email address, click here: >mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe >Or send a BLANK email with unsubscribe in the >SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.