2 grains with 2mm outside inhibitors.
On Feb 3, 2018 7:36 PM, "DH Barr" <dhbarr@xxxxxxxxx> wrote:
How many grains, and are the outsides of the grains inhibited from burning?
On Saturday, February 3, 2018, Sunny Gavali-Bhosale <
sunnygavali02@xxxxxxxxx> wrote:
Grains are KNSU made by water dissolved method. Grains are made usingstandard O/F ratio.
Grain length: 60mmsunnygavali02@xxxxxxxxx> wrote:
Grain OD: 38mm
Grain ID: 13mm
Nozzle throat: 11mm
Exit throat: 150mm
On Feb 3, 2018 7:26 PM, "DH Barr" <dhbarr@xxxxxxxxx> wrote:
On Saturday, February 3, 2018, Sunny Gavali-Bhosale <
(PVC motor)?Does spacers between propellant grains matter on actual work of motor
tend to BOOM!Because I had never used any spacers in grains and every time it did
ingredients, geometries, & preparations.Any easy idea to get over it?
It will be much easier to give good advice if you were to describe your
generally required for a 2grain 38mm exterior-inhibited BATES. Just dish
The only advice I can give would be that no, grain spacers are not
one end of the grain.