I have
1181 XYLITOL 5C 12H 5O 0 0 0 -1759
.0549]
On Sunday, April 26, 2020, Nikolai Nielsen <nielsen.nikolai86@xxxxxxxxx>
wrote:
also, does anyone have the burn data for xylitol? id like to use that asthe fuel
Nikolai Nielsenwrote:
On Sun, 26 Apr 2020 at 18:13, Nikolai Nielsen <nielsen.nikolai86@xxxxxxxxx>
analog? could it be closer to the schedule 80?
im using motorsim, would it just be safe to use the schedule 40 as the
nielsen.nikolai86@xxxxxxxxx> wrote:Nikolai Nielsen
On Sun, 26 Apr 2020 at 18:10, Nikolai Nielsen <
unfortunately. im just looking for a rough guideline so i can design
i dont have any of the sort of equipment to do any of that
wrote:Nikolai Nielsen
On Sun, 26 Apr 2020 at 18:07, Ray Rocket <dmarc-noreply@xxxxxxxxxxxxx>
due to the axial alignment of grain boundaries during the forming process.
Note that extruded tubing may not develop a very high hoop strength
doing this on homebrew motor cases anyway. A hydro test is easy and cheapBuild a test motor case and run a hydrostatic test. You should be
(say the case begins to stretch just before a tear in the wall begins), asIt is dangerous to test with air in the system. When a failure begins
nielsen.nikolai86@xxxxxxxxx> wrote:Ad Astra,
Ray
On Sunday, April 26, 2020, 09:38:50 AM MDT, Nikolai Nielsen <
aluminium pipe that used to be a tv antenna pole. I want to take a piece to
i want to get back into rocketry and ive got a 2m pole of extruded
much appreciated.
Nikolai Nielsen