[studiorecorder] Re: question about the go to command
- From: Curtis Delzer <curtis@xxxxxxxxxx>
- To: studiorecorder@xxxxxxxxxxxxx
- Date: Tue, 12 Nov 2013 00:41:07 -0800
you can start a new recording inside that large file and it then, if you
have mile stones turned on it creates markers for each starting position.
Curtis Delzer.
HS.
K 6 V F O
San Bernardino, CA.
curtis@xxxxxxxxxx
skype: curtis1014
On Wed, 9 Oct 2013 15:16:05 +0000
Sheila Winther <Sheila.Winther@xxxxxxxxxxxxxxxxxxx> wrote:
> Hi Don and SR Listers,
> I also do this, but I transfer each side of the cassette tape to a separate
> file, edit the files deleting excess blank audio and end of cassette
> announcements etc. Then I copy and paste the files into one large file. If I
> need to know where one file ended and another begins, I add a #1 navigation
> mark to the end of each file before I copy and paste. Then you can use the
> show marks command (h) and have a list of all the navigation marks and the
> ability to select a mark and go directly to that place in the file. Remember
> there is a limit to how much audio you can put in one file, depending on your
> sample and bit rate settings. Also, if you are using Book Wizard Producer to
> create a Daisy or NLS encrypted book from the files, there is no need to
> paste the files together, just make sure the files are all named the same (no
> capitals, no spaces) but ending with s01, s02, s03 and so forth. Hope this
> helps.
>
> Sheila Winther
> Volunteer Services Coordinator
> Idaho Commission for Libraries
> 325 West State Street
> Boise, Idaho 83702
> 208-639-4169
> 208-334-2150
> www.libraries.idaho.gov
>
> Volunteers are Everyday Heroes
>
> -----Original Message-----
> From: studiorecorder-bounce@xxxxxxxxxxxxx
> [mailto:studiorecorder-bounce@xxxxxxxxxxxxx] On Behalf Of Donald L. Roberts
> Sent: Wednesday, October 09, 2013 9:00 AM
> To: studiorecorder@xxxxxxxxxxxxx
> Subject: [studiorecorder] question about the go to command
>
> In my volunteer work, I transfer materials recorded on tape cassette to the
> hard drive using studio recorder. I record all of the tracks on a casette to
> one large file on the hard drive. The audio on each track is typically
> approximately 44 minutes 15 seconds in length.
>
> I am wondering whether there is any way using this command to move within the
> recorded material plus or minus 44 minutes 15 seconds. As it now stands, if I
> understand the command's use correctly, I must determine the cursor's current
> position and then add or subtract 44 minutes 15 seconds from that total.
>
> Thanks for any feedback.
>
> Don Roberts
Other related posts:
