Perhaps I should have clarified my comment as follows! 1. The reason we wrote the calculator in the first place was because we >couldn't figure out how to make the frequency response calculation for an >arbitrary number of capacitors with arbitrary values, inductance and ESR >any other way******** with the resources we had availale to us*********. >Then we figured others might have the same problem and would >like access to the same tool. >(I did not mean to imply there weren't any other tools that could do this. >And I apologize if that's the way it came across. Some of the other tools >readily available, such as Excel and Mathcad, will do the job, but with so >much overhead that for a large problem it takes forever to complete.) > Doug Brooks' new book, "Signal Integrity Issues and Printed Circuit Board Design" has just been released by Prentice Hall. See details and ordering info at www.ultracad.com ______________________________________________________________________________ ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu