Tom,
Not aware of any of this as no one locally has re-powered, other than Joe
Weathers a couple of years ago. I have copied the scoaa owners group on this
e-mail so hopefully someone will come back with some ideas. Where did you get
the engines?
Regards, Kurt
Kurt Jerman
Seawind USA
619.571.3513
From: Yacht Manana [mailto:manana1000@xxxxxxxxxxxxx] ;
Sent: Tuesday, May 11, 2010 7:56 AM
To: Kurt Jerman
Subject: RE: Seawind 1000 motors
Kurt,
We are in Shelter Bay trying to install 2 new Yamaha 9.9 GPXR motors. We have
run into some problems. The power tilt mechanism is too long for the existing
motor mount. Graham had led us to believe the GPXR was the correct motor and
apparently the GEXR would have worked better (not available in the US). We are
attempting to address tghis issue by raising the old motor mount 2".
The other issue we have is that the old 9.9s had a 7 pin wiring harness and the
new 9.9s have a 10 pin wiring harness. Are you aware of any adapters or do we
have to find a 10 pin harness and rewire the ignition?
Have you had any other Seawind 100s upgrade their motors recently?
Tom
--- On Sun, 12/13/09, Kurt Jerman <KurtJerman@xxxxxxxxxxxxxxx> wrote:
From: Kurt Jerman <KurtJerman@xxxxxxxxxxxxxxx>
Subject: RE: Seawind 1000 motors
To: "Yacht Manana" <manana1000@xxxxxxxxxxxxx>
Date: Sunday, December 13, 2009, 9:25 AM
Tom,
The 9.9 has a changed a bit over the years, and sometime varies
depending on wether it is a domestic (US) or international engine. Either will
fit in the Seawind, just need to make sure it is the 25" shaft, high thrust
with remote control and electric start and you are good.
Cheers, Kurt
Kurt Jerman
Seawind USA / West Coast Multihulls
kurt@xxxxxxxxxxxxxxx
<http://us.mc817.mail.yahoo.com/mc/compose?to=kurt@xxxxxxxxxxxxxxx>
PHONE 619 571 3513
FAX 619 269 6770
________________________________
From: Yacht Manana [mailto:manana1000@xxxxxxxxxxxxx]
Sent: Sun 12/13/2009 6:42 AM
To: Graeme Nolan
Cc: Kurt Jerman
Subject: Seawind 1000 motors
Graeme,
I am the owner of a 2000 Seawind 1000 hull #78 (Mañana). I need to replace the
engines and I wanted to ask if you have any suggestions for new engines that
will fit the 1000 footprint. I am currently in Panama and have received a
quote for the Yamaha 9.9 GPXR.
1. Is this the correct engine for the Seawind 1000
2. Is this the BEST available engine for the Seawind 1000
3. Will this engine fit in the seawind engine compartments
Any help you can provide will be greatly appreciated. Thank you.
Tom McCarthy
Mañana
Panama City, Panama
________________________________
Message protected by MailGuard: e-mail anti-virus, anti-spam and
content filtering.
http://www.mailguard.com.au ;<http://www.mailguard.com.au/>
Report this message as spam
<https://login.mailguard.com.au/report/1yROiVobGP/1zvccJJTNNBNHf0RkwbrEN/0.002>
________________________________
Message protected by MailGuard: e-mail anti-virus, anti-spam and content
filtering.
http://www.mailguard.com.au
Report this message as spam
<https://login.mailguard.com.au/report/1zRtgArcQy/3IehaM7PX1zhOnqLh2uzhq/1.18>
--
Message protected by MailGuard: e-mail anti-virus, anti-spam and content
filtering.
http://www.mailguard.com.au