I’d just leave the alcohol out and use distilled water and wetting agent. Are
you in a hurry to print? Or does someone need to use the bathroom where the
film is drying?
Mark S
Sent from my iPhone
On May 1, 2020, at 3:07 PM, Tim Daneliuk <tundra@xxxxxxxxxxxxxx> wrote:
It has long been my habit to add a small amount of 91% Isopropyl Alcohol
to my Photoflo solution to promote more rapid film drying.
With Isopropyl so hard to get right now, I can I use fuel grade Denatured
Alcohol instead, or will the denaturing agents cause damage or poor drying?
--
----------------------------------------------------------------------------
Tim Daneliuk tundra@xxxxxxxxxxxxxx
PGP Key: http://www.tundraware.com/PGP/
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your
account (the same e-mail address and password you set-up when you
subscribed,) and unsubscribe from there.