[modeleng] Re: Wood stain removing/blending
- From: "Terry Lane" <tel@xxxxxxxxxxx>
- To: <modeleng@xxxxxxxxxxxxx>
- Date: Tue, 26 Oct 2004 18:23:27 +1000
...OR, you can darken up the whole lot to match the runs
> Al, just about the only way to remove that run-over is to re-sand that
surface. Even then, that will often not remove the stain completely, but it
generally will pale the thing down enough so that it doesn't notice so much.
Spirit based stains seem to penetrate deeper than the water based ones.
> Len Smith
>
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
line.
>
MODEL ENGINEERING DISCUSSION LIST.
To UNSUBSCRIBE from this list, send a blank email to,
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.
Other related posts:
